Have a Dual Start but aren’t sure where to start? Here’s a prebuilt package to get you going.
Rocker Switch – Master On/Off
Relay – Sends power when start buttons are pushed
Fuse Holder – while not required, it’s recommended
40amp Fuse – again, while not required, it’s recommended
12ga Wire – 5′ of Red and 5′ Black
12ga Female Spade – QTY 15 – a few more than needed just in case
Additional stuff you might need but is not included.
Throttle with Start buttons or a separate Momentary Switch
12v Battery (LiFePo4 chemistry is recommended, with a high C rating, Vitto starters want 32amps!)
Battery connector (will vary based upon your battery)
Butt Splices, if you don’t like soldering
Volt/Ohm Meter, for figuring out the throttle wires and testing – always good to test!
Some sort of box to put all this on your paramotor
Lipo Fire bag wouldn’t be a bad addition either
Products you might like...